The NA48 beam consists of two distinct parts:
The checks below should be performed at least twice per shift and in any case after each access or change of condition or in case of beam problems.
K12 beam : SET-UP / MODE
STATUS / MAGS STATUS / COLLSPrint the result and glue it in the logbook at the beginning of each shift (in the K12 beam, Bends 8 and 9 refer to the 2 coils of the spectrometer magnet MNP33).
STATUS / CHECKwhich shows all the out-of-tolerance settings in the graphics window ("DICO").
For P42 : TUNE / SPECIAL / TAXThese control the relative proton flux to the KL target and are closed (position +143 mm) for access and in case of interlock alarms - see list on screen. If an interlock occurs, ask CRN to repair and reset before you can re-open TAX(7).
For K12 : SETUP / TAX / K12Write the settings for both P42 and K12 in the logbook.
STATUS / VACUUMIt is important to see that the two VACUUM VALVES (isolating the LKr calorimeter) are OPEN.
TUNE / MEAS / MWPC / PROFILE / 1 (or 2) / DICOPrint the profile (in the DICO window - choose "Print logbook inv" in the pop-up menu and click in the DICO window to produce and print a snapshot). Compare with previous profiles.
TUNE / SPECIAL / SCALERSPrint the output and glue it in the book. Compare with previous counting rates for the same beam mode.
See the P42+K12 User Guide or the Beam Handbook in the control room if you need more information.
Last updated : 30 August 1996 by LG