There are no *.mad files in this directory,
because the mad commands are stored in the
files: seqedit*
To run madx job, type e.g. : >./seqedit2006_ct
(The reason is that "the current directory" . is removed for security)
The apertures of elements and vacuum chambers are in the files .dbx
!**************************************************************
! The tt2_ct_14_2006.str file was changed, taking into account
! the real clibration curves and not the linear interpolation.
!
! Also, all the three files:
! tt2_ct_14_2006.str
! tt2_fe_26_2006.str
! tt2_fe_pb_2006.str
! was modified, by removing all references to the currents.
! The currents were put into the files:
! tt2_ct_14_2006.currents
! tt2_fe_26_2006.currents
! (the file: tt2_fe_pb_2006.currents will be added later)
!
! Modifications proposed by G.Arduini August 2006. O.Berrig.
!
!**************************************************************
!**************************************************************
!
! The files: tt10_2006.dbx
! tt10_2006.ele
! tt10_2006.seq
! tt10_ct_14_2006.str
! tt10_fe_26_2006.str
! tt10_fe_pb_2006.str
! were modified August 4 2006. They were updated with modifications
! by Jorg Wenninger:
! 1) Removal of virtual kickers:
! mdcv102902.k, mal102928.k, mdca1030.k, msi1183.k1,
! msi1183.k2, msi1183.k3 and msi1183.k4
!
! 2) Putting a "." in the names of elements.
! In the SPS ring, TI2, TI8, TT20 and TT41 (CNGS)
! the names have a "." between type and position.
! Therefore we follow the same standard.
!
! 3) Introduction of strength parameters for matching
!
!
!
! J. Wenninger is the author of these changes. August 2006 O.Berrig
!
!****************************************************************
!**************************************************************
!
! The optics files for the continuous transfer `CT' were
! modified in 2006. The reason is that the TT2 line was
! changed for the lead ions. A stripper was installed
! at ~70 m (strn)
! The following changes were made:
! QDE210 : A separate power supply was installed
! QFO215 : A separate power supply was installed
! and the magnet was replaced.
! The old magnet was type FS and the new is type FL.
! (and the lenght was thus changed from 0.8m to 1.2m)
! Naturally the QDE210 and QFO215 were taken out of the powering
! lines: QDE210.F and QFO215.F
! These lines were renamed: QDE220.F and QFO225.F. The third
! line is powered by the same power
! converter as QDE220.F. The third
! line is called KQDE240.F and the
! strength equals KQDE220.F/1.001966885636;
! QDE163 : New magnet type Q130, L=0.5
! QDE207 : New magnet type FL, L=1.2
! QDE213 : New magnet type FS, L=0.8
! QDE217 : New magnet type FS, L=0.8 (it was the old QFO215 )
!
! M.Martini is the author of these changes. June 2006 O.Berrig
!
!****************************************************************