&SIGNAL: PLOT-SIGNALS
Sets the time window within which you wish to look at the signals.
If you select AUTOMATIC, then only the part of the signals that
is non-zero will be plotted.
By default: the entire time range is shown.
Sets the vertical scale of the graphs.
[By default, the signal within the time window establishes the
full scale of the graphs. This is also what is done if you ask
for AUTOMATIC.]
Normally, all non-zero currents on the SELECTed
wires are shown.
If you're interested in only a subset of these, then list
them either by wire number or by wire label after WIRES.
Requests that the cross induced currents, if available,
are shown.
[By default, these currents are shown if available.]
Requests that the direct currents are shown.
[This is the case, by default.]
The direct current is shown with representation
FUNCTION-1,
the cross induced current with representation
FUNCTION-2.
Go to the top level,
to &SIGNAL,
to PLOT-SIGNALS,
to the topic index,
to the table of contents, or to the full text.
Formatted on 21/01/18 at 16:55.