Printing and Histogramming

General data cards

• ERRP  

  With an ERRP card the number of times any single error is printed out (reported via RERROR) can be controlled. Anyhow the total number each error has occurred will be printed in the job summary.

  Example:

          ERRP 3  ! print any error not more than 3 times

• HPRI  

  If the HPRI card is present histograms will be printed at the end of job.

• HIST  

  Card to define a PAW readable file.

  Example:

  HIST 'SCWEEK:MYJOB.HIS' ! Histograms written to file SCWEEK:MYJOB.HIS

• DEBU  

  The two numbers following this card will specify for which events you want to get printout. This numbers correspond to the event sequence number.

  Example:

  DEBU 1 50   ! Debug events from number 1 to 50.

Detector specific data cards

Each process is controlled by a card. The name of these cards must correspond to the accepted list of 4 character names (corresponding to each JULIA modules):

VDET, ITC, TPC, ECAL, LCAL, SATR, HCAL, MUON, CALO, YREC, 
YTOP, EFLO, BCAL, FALC, BOM, SICA and SKEL.

These cards are used to select histogram, and printout level that you want for each detector or module, specifying the keywords 'HIST' or 'PRIN' followed by the level number. If a non-existing keyword is specified an error message will be issued and the keyword ignored. If you put a card for a detector which is not selected in the PROC card, it will be ignored. The printout levels are defined as follows:

• Level 0 : no printout
• Level 1 : 1 line per event and per task (track finding, cluster finding,)
• Level 2 : 1 line per object (track, cluster, vertex,...)
• Level 3 : 1 line per cell (storey, TPC coordinate,...)
• Level 4 : very detailed.

Other levels will depend on every detector. To the list of detectors we have added the SKELeton, so you can select printout and histogram level for it. The levels for the SKELeton are : 1 to get printout for every run, 2 to get it for every event. The 'SKEL' keyword in the PROC card is not mandatory.

The end of job summary printout for each detector is driven by the 'EPRI' keyword. Example:

            TPC  'HIST' 4 'PRIN' 2 'EPRI' 1

This will produce level 4 histogramming ,level 2 printing for the TPC and level 1 end of job summary. To print histograms at the end of the job a card HPRI is needed. Histograms will be written onto a PAW readable file using the HIST card.