&DRIFT: OPTIONS
Requests printing of drift-line summary data in a few, nearly
forgotten, commands like TABLE.
Most commands have their local print option.
Requests plotting of the drift-lines used by for instance
XT-PLOT and
ARRIVAL-TIME-DISTRIBUTION.
The option is particularly useful to verify that prepared tracks
are interpolated with a reasonable
order, and to judge
whether there is a need to set the
COMPUTE-IF-INTERPOLATION-FAILS
option.
[The option is by default off.]
Requests labelling of the contours produced by TABLE CONTOUR. This
option is shared with the field section where it controls labelling
of the (e.g. potential) contours.
Requests that contours be drawn across all non-conducting
media.
This option is ignored if the field is computed from wires
and planes.
[This is default.]
Requests contours be drawn exclusively in the material that
has been designated as drift medium.
This option is ignored if the field is computed from wires
and planes. The option is honoured only if the dielectric
constants are present in the field map.
[Contours are by default drawn in all media.]
If active, wires will be plotted as markers and not as circles
with the size of the wire.
For further information, see the WIRE-MARKERS
option in the cell section.
Requests a verification of the map index calculation.
See the CHECK-MAP-INDICES option
in the field section for further information.
Go to the top level,
to &DRIFT,
to OPTIONS,
to the topic index,
to the table of contents, or to the full text.
Formatted on 21/01/18 at 16:55.